In the initial stage of impeller operation and all regular inspections of the blower, whenever there is an opportunity, the impeller should be inspected for cracks, wear, dust accumulation and other defects.
High pressure and high speed filling aluminum die casting mold are two main characteristics of aluminum die casting.
When the motor is under rated load, the temperature of the Motor Housing is generally not higher than 80 degrees, and is normally around 60 or 70 degrees.
Using the impeller disassembler: If there is a fan impeller disassembler on site, you can directly press down the fan shaft on the fan impeller disassembler to complete the disassembly of the fan impeller. This method is the simplest and safest. In general, the operation time is only 1-2 hours.
Auto parts processing is the unit that constitutes the whole of auto parts processing and the products that serve the processing of auto parts.
Blower Impeller is mainly composed of the following six parts: motor, air filter, blower body, air chamber, base (and oil tank), drip nozzle.
