fan blower casting cover Manufacturers

Connecting rod bushing & Rubber bushing or rubber bearing as a shock absorber is widely used in automotive chassis, mainly concentrated in the engine, transmission, drive shaft and frame or body connection, as well as suspension system. The main function is to attenuate the vibration transmitted to the body by the engine, drivetrain and road surface, which can greatly improve the NVH performance of the vehicle. Therefore, the study of mechanical properties and fatigue characteristics of rubber components has very important significance, bushing production and research and development has accumulated many years of experience, from the process, process, quality control and raw materials and other aspects of the formation of a certain standard and management!
We have:
Rubber material formulation design
CAE finite element analysisv
Spectrum signal processing capability
Mold design ability
Structural forward development capability
General sealing technology

METALLECA® Motor housings are widely used in generators and electric motor series. The power of motor is range from 1KW to 20KW. The materials of the housing are no longer limited to steel and pig iron as in the past, then the thin and lightweight stainless steel and aluminum alloy are also more popular. Our production of motor housing is made aluminum alloy and common carbon steel. The housing of the motor has a protective effect and functions as a component mounting frame. In addition, some special models of motor housings also have functions with heat dissipation or sound insulation.

Forging Process is one of the two components of forging (forging and stamping), in which forging machine is used to press metal billet to produce plastic deformation and Electric Power Fittings so as to obtain forging with certain mechanical properties, shape and size.
According to the way the blank moves, forging can be divided into free forging, upsetting, extrusion, die forging, closed die forging, closed heading forging. 1.Free forging. Use the impact force or pressure to deform the metal between the upper and lower iron (anvil block) to obtain the required forgings, mainly manual forging and mechanical forging two kinds.
2.Die forging. Die forging is divided into open die forging and closed die forging. The metal blank is obtained by compression deformation in the forging die bore of a certain shape, which can be divided into cold heading, roll forging, radial forging and extrusion, etc.
3, closed die forging and closed heading forging because there is no flying edge, the utilization rate of materials is high. It is possible to finish complex forgings with one or several processes. Since there is no flying edge, the forgings have less force area and less load required. However, it should be noted that the blank can not be completely restricted, so it is necessary to strictly control the volume of the blank, control the relative position of the forging die and measure the forging die, and try to reduce the wear of the forging die.

The METALLECA® rubber coated drive wheel is the general term of many mechanical parts that can change the scope of physical movement. The most important function is to change the force, torque or speed by combining a drive wheel set of more than two different diameters wheels. At present, the materials of drive wheel are no longer limited to the steel, pig iron, but aluminum alloy and plastics gradually also occupy in the market.

METALLECA® Harvester Accessories are applied in agricultural machinery. The agricultural machinery is rapid widespread and obviously improvement the efficiency of agricultural production. The rapid development of agricultural mechanization is one of the important characteristics in modern agriculture. Especially, the modern intelligent manufacturing has accelerated agricultural mechanization, modern agriculture, and agricultural production to meet market demand. Therefore, the production of harvester and related machinery parts are gradually increasing in demand.

Our company is an OEM/ODM supplier. Our METALLECA® Body housing and fitting joints of the production can be customized according to requirement of domestic and foreign customers. Production would follow customer’s specific requirements (assembly, performance, life, corrosion resistance, etc.) to select the appropriate processes and materials (mainly used casting aluminum alloy). Otherwise, the production and processing are based on the customer specification. We specialize in producing unpatented products and do not have our own brand. At present, we supply for supporting machinery and equipment to domestic and foreign customers only. We look forward to more inquiries and cooperation with new customers to become long-term partnership.